Discussion in 'Sea Fishing Forum - Shore, Boat & Kayak Fishing' started by Zetland, Jun 3, 2017.
I need a couple of small Marine grade bolts, who sells them round here?
About a week or two late with the question mind, been doing work on a swimming pool complex and everything was marine grade stainless, nuts bolts fixings and handrail
I need a couple of half inch to fit my transducer to a new mount, also need something to fix mount to transom.
I used a timber block, cut and shaped to fit the transom and allowed for the shape of the underside of the hull and fixed it with sikaflex and painted it afterwards, fixed the transducer to the block with 2 stainless steel screws
No holes in the boat, that was about 8 years ago and still as good as new
Will have a look but dont think I picked up anything that big
M6 half inch long, not wide.
You'll be alright using zinc plated / galvanized bolts. They can be bought at any DIY shop, just replace them when they start to rust. If you want to go the stainless route you'll need A4 or better quality , try Hawk fasteners skippers lane indutrial estate.
Might have some of those, washers and nylock nuts, will have a look later
these any good?
I'm in Marton if you are passing you can have them
They are stainless steel suitable for offshore etc
0782 8171 518
You lot are like buses.
Thanks to Brian, and Scrubbs for the offer, job's a goodun.
I don't know what I'm looking at ...but.. it does look good.
Looks like a successfully fixed transducer mount to a rib to me
Job done I reckon
Separate names with a comma.